Panasonic CQ-R825 - Manuel (Page 27)

Electrical Connection
This unit can be connected to an optional CD changer (CX-DP600EUC). For details consult your nearest
Panasonic dealers.
For connection to a CD changer, refer to the operating instructions of the CD Changer (CX-DP600EUC).
Caution:
• To prevent damage to the unit, be sure to follo\w the connection diagram below.
• Remove the covering of the leads about 5 mm long from their end before connecting.
• Do not insert the power connector into the unit until the wiring is completed.
• Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and
keep cable terminals free from touching any metal parts.
CX-DP600EUC
Extension Cord (DIN/BATT/RCA)
=CBflil
Insert the ground lead into
the notch of the chassis.
Ground lead
(To a clean, bare metallic
part of your vehicle.)
(Yellow)
\ BATTERY|:^^|Sb3=i
Fuse (ЗА) Battery Cord
Be sure to connect to a well grounded metallic
part of your car because noises or troubles
may occur.
To a constant power supply
(White) (White)
w
(Red) (Red) CQ-R825/R805EUC
CD Changer
Control Connector
J
DIN Extension Cord
• H
White w/Blac4
Stripe
(D Power Connector
SPEAKER LEAD
Gray w/Black Stripe
ïl BAHERYtOA tl L—I
Fuse(tOA)
\ ACC
Red
Resistor (1kO)g,3^,^
Dark Blue
BATTERY LEAD
(Connect to car battery)
POWER
(+12V DC, negative
ground only)
GROUND
(Connect to a clean,
bare metallic part of
your vehicle.)
MOTOR ANTENNA
RELAY CONTROL
(moves antenna up
and down)
Violet w/Btack Stripe
FROMT SP^j^REAR “sp^
|гее^/В1аск|((сгееп ¡o,gt
LEFT SPEAKER RIGHT SPEAKER
(FRONT) (FRONT)
LEFT SPEAKER RIGHT SPEAKER
(REAR) (REAR)
CQ-R825/R805EUC
27