Panasonic WV-BL730 - Manuel (Page 32)

8. Repeat the procedures above to obtain a satisfac­
tory setting,
9. Move the cursor to RET and press EJ to return to
the CAM SET UP menu.
Notes:
• Masking or adjusting the detection level is needed
to prevent malfunction under the following condi­
tions:
• When shooting an object under flickering fluores­
cent light or shooting in ELC.
• When leaves or curtains etc. are swayed by the
wind.
• When the object is lighted by lighting equipment
that constantly turns on and off.
• It takes about 0.2 seconds for the alarm signal to
reach the alarm terminal of the VCR after the cam­
era detects the object.
Because the alarm signal is multiplexed on the
video signal, it may be mistakenly interpreted by
other video equipment as a time code signal.
Therefore, when camera is not used in a
Panasonic Intelligent CCTV System select OFF to
prevent the above from occurring.
8. Lens Drive Signal Selection (LENS
DRIVE) .
This item is used to select the type of auto iris lens
drive signal to be supplied to the lens from the auto iris
lens connector.
*• CAM SET UP ••
CAMERA ID OFF “1
A1X:/ELC ALC ~l
SHUTTER OFF
AGC ON
SEHS UP OFF
smc INT
MOTION DBT OFF 1
LENS DRIVE
‘ixrV.
END
SET
UP EMABIiB
Move the cursor to the LENS DRIVE parameter.
Select DC if you are using the auto iris lens that
requires a DC drive signal.
Select VIDEO if you are using the auto iris lens that
requires a video drive signal.
-
30
-