Panasonic WV-BL730 - Manuel (Page 30)

2. After confirming the cursor is on LL, press El •
The vertical phase adjustment menu appears on
the monitor.
• « STMC **
V PHASE
COARSE
riUE I........
BET END
^_________
3.
4.
5.
6
.
Move the cursor to COARSE. The cursor starts
blinking.
Supply the video output signal of the camera to be
adjusted and the reference camera video output
signal to a dual-trace oscilloscope.
Set the oscilloscope to the vertical rate and
expand the vertical sync portion on the oscillo-_
scope.
Press ^ or to match the vertical phase for
both video output signals as closely as possible.
(COARSE adjustment can be incremented in 16
steps by 22.5 degrees by pressing ^ or [^.)
1 (1 - -16): 0 degrees
2 (1 - -16): 22.5 degrees
16 (1 - - 16): 337.5 degrees
Note: After the sixteenth step, the adjustment
returns to the first step.
7. Move the cursor to FINE. The cursor starts blink­
ing.
8. Press ^ or to match the vertical phase for
both video output signals as closely as possible.
(FINE adjustment can be made up to 22.5 degrees
by pressing ^ or [^.)
Notes:
• When the “I” cursor reaches the end, it
jumps back to At the same time, COARSE
Is incremented by one step to enable a contin­
uous adjustment. The reverse takes place
w/hen the “I" cursor reaches the end.
• When ^ or is kept pressed for a second
or longer, the ‘T cursor moves faster.
-
28
-