Panasonic WJ-HD500 - Manuel (Page 9)

Alarm Port (ALARM)
This port accepts the alarm input from the associated
alarm sensors through either Normally Open or
Normally Closed contacts.
The pin assignment of the port is shown below.
@ Remote Port [REMOTE (WV-CU50)]
This port is provided for controlling the Disk Recorder
with the optional WV-CU50 Remote Controller.
To connect to the controller, use a 6-conductor modular
cable supplied as an accessory with the controller.
® © ® ® ® ® ® ® ® @ ® ®
ALARM 14
Pin
No.
Designation
Pin
No.
Designation
1 Alarm Input 1 14 Ground
2 Alarm Input 2 15 Alarm Input 5
3 Alarm Input 3 16 Alarm Input 6
4 Alarm input 4 17 Alarm Input 7
5 Sequence Timing Input 18 Alarm Input 8
6 Alarm Reset Output 19 Alarm Input 9
7 Ground 20 Ground
8 Alarm Recover Input 21 +5 V Output (0.2 A)
9 Alarm Output 22
Recording Timer Select
Input
10 Alarm Input 10 23 Alarm Input 14
11 Alarm Input 11 24 Alarm Input 15
12 Alarm Input 12 25 Alarm Input 16
13 Alarm Input 13
® Serial Port (SERIAL)
For connecting a Personal Computer.
Signal Ground Terminal (SIGNAL GND)
@ 10/100BASE-T Port (Optional)
An optional Network Board can be installed in the Disk
Recorder.
This port is used to exchange control data with Ethernet
via an Ethernet Hub.
Cooling Fan
Prevents the temperature of the Recorder from rising,
Do not block the ventilation opening on the cover.
AC Inlet Socket (AC IN)
Plug the power cord (supplied as a standard accesso­
ry) into this socket and connect it to an AC outlet.
® Power Switch (POWER ON/OFF)
This switch turns the power of the Disk Recorder on and
off.
@ Video Output Connectors (VIDEO OUT 1-16)
The video signal connected to the Video Input
Connector (VIDEC IN) is looped through these connec­
tors with an automatic 75 Q termination.
® Video Input Connectors (VIDEO IN 1 -16)
These connectors accept either a color or B/W compos­
ite video signal from the camera.
Copy Port (COPY)
For connecting the optional DVD-RAM Drive unit.
Mode Selector (MODE)
Selects data termination for PS Data system expansion.
Data Port (DATA)
Exchanges control data with the external device with PS
Data {Panasonic Security Data) mode.