Communication setup, Unit address setting, Baud rate – Panasonic WJ-HD500 Manuel d'utilisation
Page 62: Ps data setup, Data bit
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
COMMUNICATION SETUP
The procedures described below let you set the parame
ters for the Disk Recorder to communicate with external
devices.
1. Move the cursor to COMMUNICATION SETUP in the
WJ-HD500 SETUP menu by pressing the
T
or
A
but
ton, then press the SET button.
The COMMUNICATION SETUP menu shown below
appears on the monitor screen.
8 COMHUNICATIOH SETUP
PS'Data SETUP 1
RS232C SETUP 1
NETWORK SETUP
IP
ADDRESS-
192.168.000.010
NETHASK-
255.255.255.000
GATEWAY-•
192.168.000.001
2. Select an item or item parameter in the menu by press
ing the
A
or ▼ button,
3. To return to the previous setup menu, press the
SETUP/ESC button
• Unit Address Setting
This item lets you set the unit address of the Disk Recorder
in the system for RS-485 communication.
1. Move the cursor to the UNIT ADDRESS parameter by
pressing the
A
or
T
button.
2, Select the unit address number to be used for RS-485
communication by pressing the 0 or 0 button.
Select a parameter value between 001 and 099.
The factory default setting is 001,
2. Select an item or item parameter in the menu by press
ing the
A
or ▼ button.
3. To return to the previous WJ-HD500 SETUP menu,
press the SETUP/ESC button.
• Baud Rate
This item lets you set the transmission speed for RS-485
communication.
1. Move the cursor to the BAUD RATE parameter by
pressing the
A
or ▼ button.
■ PS Data Setup
These items let you set the parameters for communication
between the System Controllers and the Disk Recorders
when the system is controlled with the PS Data mode
(Panasonic Security Data).
2. Select the desired transmission speed shown below by
pressing the 0 or 0 button.
C
2 400
4 800
9 600 4-^19 200
38 400
3
The factory default setting is 9 600 bps.
1. Move the cursor to PS*Data SETUP in the COMMUNI
CATION SETUP menu by pressing the
T
or
A
button,
then press the SET button.
The PS*Data SETUP menu shown below appears on
the monitor screen.
• Data Bit
This item lets you set the number of data bits for RS-485
communication.
The factory default setting is 8 bits and fixed.
" ' ^
8-1 PS*Data SETUP
UNIT ADDRESS
001
BAUD RATE
9600
DATA BIT
8
PARITY CHECK
NONE
STOP BIT
1
WAIT TIME
OFF
ALARH DATA
IS
CAMERA NUMBER SETUP
63