Panasonic PANASYNC S50 - Manuel (Page 5)

[
Federal Communications Commission Requirements )
This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to Part 15 of the FCC Rules, These limits are designed to provide reasonable pro­
tection against harmful tnterfereixe in a residential installation. This equipment generates,
uses, and can radiate radio frequertcy energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or rmre of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC Warning:
To assure continued FCC compliance, the user must use grounded power supply cord
and the provided shielded video interface cable with bonded ferrite cores.
Also, any unauthorized changes or modifications to this monitor would void the users auth­
ority to operate this device.
( CE Conformity )
C€ This device complies with the requirements of the EEC direcfice 89/336/EEC as
amended by 92/3VEEC and 93/68/EEC Art. 5 with regard to "Electromagnetic
compatibility', and 73/23/EEC as amended by 93/68/EEC Art. 13 with regard to
"Safety".
Required Hern Relative Standard Value Relative to those Exceeding Standard Value Remarks
EMI #1 ~—-- ------ #4
ESD #2 #3
RADIATED RF #1 #3
\/
TRANSIENT F/B #1 #3
A,
LINE HARMONICS #1
#1: Satisfies standards with no problems in performance and reliability.
#2: Effects may appear temporarily on the screen but there will be no problem in reliability.
#3: There is fear of the product breaking down.
#4: If a signal cable other that specified is used, it will be the cause of electromagnetic wave
interruption of peripheral devices.
To assure continued CE compliance the user must use the provided 1.5 m shielded video
signal cable with bonded ferrite cores at both erxJs of the cable.
Handle correctly in accordance with the instruction manual.
EMI: Electromagnetic Interference ESD: Electrostatic Discharge
RF: Radio Frequency
F/B: Fast Burst
As an E nergy S tar ® Partner, Panasonic Computer Peripheral Company has determined
that this product meets the E nergy S tar ® guidelines for energy efficiency.