Panasonic PANASYNC S50 - Manuel (Page 21)

VESA DDC1/2B
^eelsthe requirements for Windows 95 Plug & Play)
The S50 monitor features the VESA DDC (Display Data Channel) standard which when used
with a DDC compatible video card, will simplify the monitor's set-ip. The S50 can operate in
the unidirectional DDC1 or bi-directional DDC2B modes.
The S50 is capable of continuously transmitting its Extended Display IDentification (EDID), or
complete Video Display InterFace (VDIF) data using DDC2, level B commands. The EDID data
contains the display identity and the basic display specifications as defined in the VESA VDIF
standard If a DDC2 capable host is detected by the S50, it will switch to a bi-directional DDC
2 communications channel until the monitor is turned off.
DDC Is a communications channel and a commartd protocol which allows a DDC compatible
monitor to communicate with a DDC compatible video card. The monitor sends signals to the
card informing the card of the factory preset modes. Then a table is created which matches
the maximum refresh rates of the monitor with those of the video card.
So for example, when you chose an addressable format (for example 1,024X 768) in Windows
95, the monitor will automatically run at a high refresh rate using Windows 95 Plug & Play wNch
can use the DDC1/2B communications to set the highest refresh rate for the combination of
SSO monitor and DDC compatible video card installed In your computer and selected
addressable format.
To start the DDC protocol Is simple;
First turn on the monitor and then turn on the computer.
That's all. Some DDC compliant video cards will allow you to save the compatibility information
in your AUTOEXEC.BAT file. After you have done tWs it does not matter which is turned on
first. If not, just be sure to turn on the morvtor before the computer to activate DDC.
Note: Some older computer systems are not compatible with the DDC standard. If your moni­
tor is displaying a monochrome image or the wrong resolution, call Panasonic’s Technical
Support Group at 1-800-726-2797 (In the USA only).
Technical Support (USA Only)
If you have read the
Operating Instructions and
tried the trouble - shooting
procedures and are stiii
having difficulty, please con­
tact the dealer from whom
the unit was purchased. You
may also call the end user
Technic^ Support telephone
number which is operational
twenty four (24) hours a day
seven days a week.
To contact the Technical Support Group call:
1-800-726-2797 (24 Hours a day)
To locate the Nearest Authorized Panasonic Service Center
call: 1-800-726-2797 (24 Hours a day)
To obtain Operating Instructions or Service Manuals Call:
Phone: 1-800-833-9626 or 1-253-395-7343
Fax: 1-800-237-9080
(6:00 AM to 4:30 PM Pacific Time)
To locate the Nearest Sales Dealer call:
1-800-742-8086 (24 Hours a day)
To get the latest Windows 95 Panasonic Monitor.
INF Files call:
PanaTech BBS (201) 863-7845 (24 Hours a day)
You may also wish to see .our world wide web pages at:
http V/www .Panasonic .com/ative
— 16 —