Thetford 2118 Series Disp - Manuel (Page 9)

Installation and Owner’s Manual 9
Connect the water supply line:
Install a 1/4 in. OD water supply line [43] from the water shut off valve of the vehicle to the solenoid water valve [44] at the rear of the
refrigerator (See Art02501):
A brass compression nut [45], a brass sleeve, a plastic
sleeve [46], and a brass insert [47] are supplied and
attached to the rear of the refrigerator (See Art01702).
- Put the compression nut and then the sleeve onto the water supply
line [43].
- For copper tubing, use the brass sleeve.
- For plastic tubing, use the plastic sleeve [46].
- For plastic tubing with .040 in. wall thickness, also use the brass
insert [47].
- Flush the water supply line until the water is clear.
- Put the water supply line into the compression fitting of the solenoid valves.
- Tighten the compression nut by hand (hard finger tight).
- Using two wrenches, tighten the compression nut 1 ½ to 2 turns.
- Open the water shut off valve of the vehicle.
- Examine the connections for leaks.
Art01702
47 43 46 45
NOTICE
44
43
ART02501