Connect the water dispenser, Notice – Thetford 2118 Series Disp Manuel d'utilisation
Page 8

Installation and Owner’s Manual 8
The doors are made to accept decorative panels. The
decorative panels must be 3/16 inch or less in thickness.
Install the decorative door panels in the refrigerator doors
before installing the refrigerator in the vehicle.
1. Make two upper door panels that are 17 1/4 inches wide x 23 1/8
inches high:
- Raised panels must be centered on each door and no larger than 16
1/2 inches wide x 22 3/8 inches high.
2. Make a lower RH door panel that is 17 1/4 inches wide x 42 5/16
inches high:
- Raised panels must be centered on the lower RH door and no larger
than 16 1/2 inches wide x 41 9/16 inches high.
3. Make a lower LH door panel that is 17 1/4 inches wide x 34 5/8 inches
high:
- Raised panels must be centered on the lower LH door and no larger
than 16 1/2 inches wide x 33 7/8 inches high.
4. Install the decorative door panels:
- Pull the panel retainer [37] off of each door [39] (See Art01804).
- Push a decorative door panel [38] into the slots of each door.
- Make sure that each panel retainer is correctly positioned and push the
curved snap [125] of the panel retainer [37] inside of the curved snap
[126] of the door (See Art01805).
- Make sure that the decorative door panel [38] of the lower LH
refrigerator door is behind the water dispenser panel.
Install Decorative Door Panels (non-metal door models)
39
38
37
Art01804
37
126
125
Art01805
Connect the Water Dispenser
The water dispenser is assembled to the refrigerator at the factory as optional equipment. If the refrigerator does not have a factory
installed water dispenser, one can not be added to the refrigerator at a later time.
The refrigerator installer must connect a cold water supply line to the solenoid valve at the rear of the refrigerator. The following are
necessary to connect the water dispenser.
- 1/4 in. OD copper tubing for the water supply line.
OR
- 1/4 in. OD plastic tubing for the water supply line.
- 1/4 in. shut off valve in the water supply line. This should be easily accessible through the lower intake vent.
NOTICE