Thetford 2118 Series Disp - Manuel (Page 5)

Installation and Owner’s Manual 5
To prepare the water dispenser for seasonal storage (See Art02501):
Do not operate the water dispenser when
the ambient air temperature is 0° F. or lower.
Damage to the water solenoid valves and the
water supply line can occur.
1. Close the vehicle water supply valve to the refrigerator.
2. Remove the water supply line [43] from the water solenoid valve
[44].
3. Remove the water dispenser line from the water solenoid valve.
- Do not remove the foil heaters from around the water solenoid
valve and the water dispenser line
Drain the water dispenser. Failure to drain
the dispenser can cause damage to the
dispenser components and result in leaks.
4. Drain all of the water from the water supply line and the water dispenser line.
Make sure to use a large enough container to catch the water that drains from the dispenser water line. The water
dispenser contains almost a quart of water.
Water Dispenser Storage
CAUTION
!
CAUTION
!
NOTICE
5. Put the ends of the water lines and the water solenoid valve each into a clean plastic bag.
6. Use tape to close each plastic bag around the water lines and the water solenoid valve.
To use the water dispenser after seasonal storage:
1. Remove the tape and plastic bags from the end of the water lines and the water solenoid valve.
2. Connect the dispenser water line to the water solenoid valve.
3. Connect the water supply line to the water solenoid valve.
4. Open the vehicle water supply valve to the refrigerator.
5. Push and hold the dispenser arm until the water comes out in a steady stream and does not sputter.
You should discard and not use the first several glasses of water from the water dispenser. NOTICE
Replacement Parts
You may purchase replacement parts through your local RV dealer or authorized Norcold Service Center.
44
43
ART02501