Sony TCM-465V - Manuel (Page 5)

Note
The battery life may shorten depending on the operation of the unit.
House Current
(see Fig. Q-0)
Connect the AC power adaptor to DC IN 3V and to the wall outlet. Use
the AC-E30HG AC power adaptor (not supplied). (For TCM-36: For Japan
use the AC-E30M, not supplied) Do not use any other AC power adaptor.
Polarity of the plug
Note
Specifications for AC-E30HG varies for each area. Check your local
voltage and the shape of plug before purchasing.
^ Operating the Unit
Recording
(see Fig.
m
®, ®)
You can record right away with the built-in microphone.
Make sure that nothing is connected to the MIC jack.
1 Press the counter reset button to reset the tape counter.
2 Insert a normal (TYPE I) tape with the side to start recording facing
the cassette holder.
For TCM-465V/459V;
S] SetVORto:
ON to start and pause recording automatically to the sound.
OFF to start and stop recording manually.
For TCM-459V:
Set MIC SENS to select the sensitivity of the microphone to:
H (high) to record at meetings or in a quiet and/or spacious
place.
L (low) to record for dictation or in a noisy place.
Note
When the sound to be recorded is not loud enough, set the VOR
switch to OFF, or the unit may not start recording.
For TCM-465V;
• To use the microphone in a standing position
When you record a lecture or a speech, use the microphone in a
standing position.
0 Slide the POP-UP MIC switch
as illustrated.
d) Face the microphone toward the sound source.
• To use the microphone without standing it
When you want to record a wide range for conversations in a
meeting, etc., use the microphone at a flat angle.
Place the unit on a hard surface such as a desk with the cassette
holder side up so that the flat mic can record effectively.
For TCM-459V/36:
Place the unit on a hard surface such as a desk with the cassette
holder side up so that the flat mic can record effectively.
Note
When using the microphone in a standing position, the sensitivity
will be higher than.the flat mic.
5 Press # REC.
Recording starts.
While the tape runs, the BATT/REC lamp lights and flickers
depending on the strength of the sound.
At the end of the tape, recording stops and the unit turns off
automatically.