Aerus CondoLux - Manuel (Page 17)

17
TROUBLESHOOTING
Your new vacuum cleaner is built to perform for a long time at high efficiency. If the machine is
not delivering its usual cleaning power, review this list.
WARNING
Disconnect all cords from electrical outlets and the hose from the wall inlet before performing any type of maintenance.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Cleaner will not run. 1. Main power unit cord and/or hose 1. Plug main power unit cord and/or
assembly unplugged at electrical hose assembly unit in firmly; turn
outlet/wall inlet. power switch to “I”.
2. Tripped circut breaker/blown 2. Reset circut breaker or replace fuse.
fuse at household service panel.
3. Function switch in wrong position. 3. Check position of function switch for
operation: “I” for operating locally, “O”
for operating remotely. (See pg. 7,
Operating Instructions.)
4. Power Switch in off position. 4. Check switch position.
Poor job of dirt pickup. 1. Airflow blockage. 1. Check hose receptacle, wands,
hose and accessories for blockage
2. Suction control is open. 2. Close suction control.
3. Worn power nozzle brush. 3. Call your Aerus™ representative.
4. Power nozzle not running. 4. Remove caught object. Reset
power nozzle reset button.
5. Power nozzle brush not turning 5. Call your Aerus™ representative.
because belt is broken.
6. Dirt bucket full. 6. Check and empty if necessary.
7. Filter clogged. 7. Clean filter.
Power nozzle will not 1. Loose hose electrical 1. Check hose handle, wands and power
run when plugged in. connections. nozzle elbow for correct latching.
2. Brush jammed due to excessive 2. Remove caught object and clean
dirt build up or caught object. brush area. Push reset button and
restart.
3. Worn or broken belt. 3. Contact an authorized Aerus location
for service.
4. AC cord not plugged in. 4. Verify cord is connected to AC outlet.
Cleaner picks up 1. Suction too strong. 1. Open suction control.
movable rugs OR power
nozzle pushes too hard.
Handle switch will not 1. Hose connection twisted 1. Rotate hose end to correct
control main power unit. in wall inlet. position (Refer to page 11).
Contact your local Aerus Representative if problems persist.