Rockwell Automation 1756-Lx_Mx ControlLogix Controller and Memory Board Installation Instructions - Manuel (Page 29)

ControlLogix® Controller and Memory Board 29
Publication 1756-IN101J-EN-P - November 2004
Update the Controller
1. Connect the controller or chassis to the same network as your
workstation.
2. Start ControlFLASH software.
3. Choose Next >.
4. Select the catalog number of the controller and choose Next >.
5. Expand the network until you see the controller.
TIP
RSLogix 5000 software, revision 10.0 or later, lets
you update the firmware of a controller as part of
the download sequence. To update the controller,
download your project and follow the prompts of
the software.
IMPORTANT
If the required network is not shown, first
configure a driver for the network in RSLinx
software.
To expand a network one level, do
one of the following:
• Double-click the network.
• Select the network and
press the
→
key.
• Click the + sign.
Workstation
Linx Gateways, Ethernet
driver
communication module
backplane
controller
−
+
−
−
−
+