Rockwell Automation 1756-Lx_Mx ControlLogix Controller and Memory Board Installation Instructions Manuel d'utilisation
Installation instructions, Are you replacing a controller that has failed

Publication
1756-IN101J-EN-P - November 2004
Installation Instructions
ControlLogix® Controller and Memory Board
Are You Replacing a Controller That has Failed?
For abbreviated steps, see page 4.
Product
Catalog Number
Series
ControlLogix5550 controller
1756-L1, 1756-L1M1, 1756-L1M2, 1756-L1M3
A
ControlLogix5555 controller
1756-L55, 1756-L55M12, 1756-L55M13,
1756-L55M14, 1756-L55M16, 1756-L55M22,
1756-L55M23, 1756-L55M24
A
ControlLogix5561 controller
1756-L61
A, B
ControlLogix5562 controller
1756-L62
A, B
ControlLogix5563 controller
1756-L63
A, B
ControlLogix5550 memory
board
1756-M1, 1756-M2, 1756-M3
A
ControlLogix5555 memory
board
1756-M12, 1756-M13, 1756-M14, 1756-M16,
1756-M22, 1756-M23, 1756-M24
A
Industrial CompactFlash
card
1784-CF64
n/a
WARNING
An electrical arc can occur if you:
• insert or remove the CompactFlash card
• insert or remove the controller while backplane power is on
• connect or disconnect the battery
• connect or disconnect the serial cable with power applied to this
module or the serial device on the other end of the cable
This could cause an explosion in hazardous location installations. Make sure
that power is removed or the area is nonhazardous before proceeding.
Document Outline
- 1756-IN101J-EN-P, ControlLogix Controller and Memory Board Installation Instructions
- Are You Replacing a Controller That has Failed?
- Table of Contents
- Replace a Suspected Failed Controller
- Avoid These Common Errors
- Make Sure that You Have All the Components
- Make Sure You Have the Correct Memory Board
- Determine Which Firmware Revisions to Use
- Prepare the Chassis
- Remove the Controller from the Chassis, If Required
- Install a Memory Board on a ControlLogix5550 or ControlLogix5555 Controller
- Install a 1784-CF64 Industrial CompactFlash Card in a ControlLogix5561, ControlLogix5562, ControlLogix5563 Controller
- Connect a Battery
- Install the Controller into the Chassis
- Check the BAT LED
- Check the OK LED
- Update the Controller
- Connect a Serial Cable
- Interpret Controller LEDs
- Clear a Major Fault
- Specifications: ControlLogix Controllers - Sheet 1 of 2
- Specifications: ControlLogix Controllers - Sheet 2 of 2
- Specifications - 1784-CF64 Industrial CompactFlash Card
- Certifications
- Environment and Enclosure Information
- European Hazardous Location Approval
- North American Hazardous Location Approval
- Back Cover