Rockwell Automation 1756-HIST2G FactoryTalk Historian ME 2.2 Installation Instructions - Manuel (Page 15)

FactoryTalk Historian Machine Edition Module 15
Publication 1756-IN106A-EN-P - March 2011
Connect the Module to the Ethernet Network
Attach the RJ45 connector the Ethernet port on the front of the module as
shown.
WARNING
If you connect or disconnect the Ethernet cable with power applied to this
module or any device on the network, an electrical arc can occur. This
could cause an explosion in hazardous location installations. Be sure that
power is removed or the area is nonhazardous before proceeding.
IMPORTANT
We recommend connecting the module to the network
via a 100 MB Ethernet switch, which will reduce
collisions and lost packets and increase network
bandwidth. For detailed EtherNet connection
information, see the ControlLogic Ethernet/IP Bridge
Module Installation Instructions, publication number
1756-EN2T IN603B-EN-P.