Whirlpool W10277499 - Manuel (Page 6)

6
Remove hinge hole cover
26.
Your dryer will either have a plastic strip or label covering the
hinge holes. If you have a plastic cover, use a screwdriver to
gently pry off the plastic bolt hole cover. If your bolt holes are
covered with a label, gently peel the label off.
Move hinge to other side and
replace screws
22.
Replace bolt hole covers
on other side
23.
Use bolt hole covers to avoid damaging previously used screw
openings on dryer door. If your bolt hole covers are labels,
you will find replacement labels with parts included with door
reversal kit. Peel replacement labels off paper backing and
press over bolt holes. If you have plastic bolt hole covers, you
may reuse them by snapping them into screw holes, or you may
replace with the provided labels as previously described.
Move hinge to other side of door and reattach using four screws.
Reassemble door
25.
Reattach the two door sections by replacing all six screws,
as shown.
Remove the door strike
and insert on opposite side
27.
Remove strike and insert in coresponding hole on other side
of front panel.
Replace inner door assembly
24.
Place the inner door assembly back onto the outer assembly,
gently lining up the window areas so that they match.
HELPFUL TIP: Use a soft cloth to remove any fingerprints
from the inside glass panels before putting the two pieces
back together.