Whirlpool W10277499 - Manuel (Page 4)

4
Reattach door hinge to other
side of dryer
15.
Reattach door on left side of dryer, using four screws, as shown.
Now, continue with the Door Reversal Completion Checklist.
Replace inner door assembly
10.
Reassemble door
11.
Place inner door assembly back into the outer door assembly.
Rettach the two door sections by replacing all six screws,
as shown.
Remove hinge hole cover
12.
Your dryer will either have a plastic strip or label covering
the hinge holes. If you have a plastic cover, use a screwdriver
to gently pry off the plastic bolt hole cover. If your bolt holes
are covered with a label, gently peel the label off.
Remove the door strike
and insert on opposite side
13.
Remove strike and insert in coresponding hole on other side
of front panel.
Replace hinge hole cover
on other side
14.
Use hinge hole covers to avoid damaging previously used screw
openings on dryer door. If your hinge hole cover is a label, you
will find a replacement label with parts included in door reversal
kit. Peel replacement label off paper backing and press over
screw holes. If you have a plastic hinge hole cover, you may
reuse by snapping it into screw holes, or you may replace with
label covers as previously described.