Pioneer DCS-340 - Manuel (Page 23)

Surround sound and other settings 06
23
En
English
Français
Deutsch
Nederlands
Italiano
Español
• LFE Off – LFE channel is not played
DTS CD setting
If you play a DTS-encoded CD, you will need to
change this setting to hear the decoded signal.
When CD Type? appears, press ENTER, then
use / to select the setting:
• NormalCD – Regular CD playback, DTS-
encoded CDs output a noisy signal
• DTS-CD – Proper decoding of DTS-
encoded CDs, but regular CD playback
may lose quality
Setting the channel levels
You can set the relative channel levels from
your main listening position for all of the
listening modes independently. 1
If you have completed Using the Auto MCACC
setup for optimal surround sound on page 6,
the channel levels will already be set. You can
still fine-tune the levels here if you need to.
1 Select a listening mode.
Press SURROUND, ADVANCED or FRONT
SURROUND repeatedly to select the listening
mode you want.
2
2 Press TEST TONE to hear the test tone.
The test tone is output in the following order
(from the speakers active in the current mode):
• L – Front left speaker
• C – Center speaker
• R – Front right speaker
• RS – Right surround speaker
• LS – Left surround speaker
• SW – Subwoofer 3
3 Use the MASTER VOLUME +/– button to
adjust the volume to an appropriate level.
Turn down the volume to
40 or less to ensure
you have adequate headroom.
4 Use / to adjust the speaker levels in
turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
5 When you’re done, press ENTER to exit
the test tone setup.
Note
1 • The SURROUND modes are divided into two independent groups: multichannel listening modes and stereo modes.
• The speaker volume can be adjusted while listening to any sound source you want by pressing CH LEVEL and then using
/ to adjust the channel levels. After finishing a channel, use / to move to the next.
2 When the Auto listening mode is selected, using the test tone method will adjust levels for multichannel sources only. Use
CH LEVEL and / (see footnote above) to set levels for the Auto listening mode with two channel sources.
STANDBY/ON
CD FM/AM
OPEN CLOSE
DVD TUNER TV LINE
L1/L2
4 4
0
1 ¡
8
7
3
FRONT
SURROUND
4 4
DVD MENU RETURN
MUTE
7
ENTER
MASTER
VOLUME
BASS
MODE
1 2 3
REPEAT AUDIO ANGLE RANDOM SUBTITLE PROGRAM
4 5 6
7 9
MAIN SUB
ENTER
5
SUB
0 CLR
8
TEST TONE CH LEVEL
ZOOM TOP MENU
DIMMER
DISPLAY
ADVANCED
SOUND
DIALOGUE
SURROUND
SETUP
SYSTEM
MIDNIGHT QUIET/
CLOCK TIMER/
3 Since the subwoofer produces ultra-low frequencies its sound may seem quieter than it actually is.
Setting_up_for_surround.fm 23 ページ ２００４年１２月２４日 金曜日 午後２時５１分