Dock Edge + Flexi-Flag Pole - Manuel (Page 3)

Dock Edge + Inc. #6018, 6018A, 6018C
Flexi-Flag Pole
Tube Stop Markers
Your Flexi-Flag Pole kit contains 3 pcs. of tubing and 1 rod section.
The tubes fit into each other starting from the largest and working up to
the smallest rod as shown above. The tube and rod must be assembled on a
flat horizontal surface. Layout the tubes along the ground. Follow the
instructions on the epoxy kit provided and mix up about 1/4 of the tube ONLY.
After you have mixed the epoxy properly, apply to the INSIDE of the large tube.
Insert the second largest tube into the large tube and with a turning motion twist the
upper section into the lower until you reach the tube stop. This will evenly
distribute the epoxy on the tube and make a good bond. Repeat the above
procedure for the other two sections. NEVER APPLY THE EPOXY TO THE
OUTSIDE OF THE TUBE, ONLY ON THE INSIDE.
While the epoxy is drying, mount the base on your selected location using
the provided mounting hardware. Predrill the mounting lag holes with a 1/4"
drill bit.
After you are sure the epoxy has cured (approx 20 min.) slip one nylon swivel
above the top swivel stop and one below the bottom swivel stop. Clip the
stainless steel flag clips through the nylon swivels (Small End) and then through
the grommets on the flag.
Open the base thumb screw, raise the flag and pole and insert into the base.
Tighten the thumb screw so the pole is secure in the base.
DO NOT OVER TIGHTEN AS THE BASE IS A CLOSE FIT TOLERANCE.
To remove or replace the flag simply remove the pole from the base as
above. Always dispose of used flags in a dignified manner.
If and when you require any replacement parts such as the swivels or flags
call your local dealer or call / FAX
Assembly Instructions
Base
Non Snag Swivels
Dock Edge + Inc. PO Box 6, River Drive Park, Ontario, Canada, LOG 1SO
Office: Ph/FAX (416)853-1863 Plant: Ph (416)738-8884 FAX (416) 738-8295
Finished Assembly
Mounted Pole & Flag
Your Flexi-Flag Pole is
designed to flex in the wind
unlike rigid steel poles.
Because there are no lines
to tangle the flag will blow
with the wind. This feature
can be used as a wind
direction indicator, much
like a wind sock. The pole is
non conductive, but any
flag pole should not be
located where it could come
in contact with Hydro Lines.
Fly your colors with pride
Kit Contains:
(3) Tube Sections
(1) Rod Section
(1) Ball,
(2) Swivels
(2) SS Flag Clips
(4) 3/8" SS Lag Bolts
(4) SS Washers
(1) Mounting Base
(1) Thumb Screw
(1) 2 Part Epoxy Kit
(1) Instructions
6018, No Flag
6018A, American Flag
6018C, Canadian Flag
Depth Marker
Depth Marker
Depth Marker
Flag Size
27" x 54" Grommet Mount
The Swivel System Designed Into This Product
Greatly Reduces Flag Tangles
SS Flag Clip
Nylon Swivel
Swivel Stop
Made In Canada
Dock Edge + Inc.
35 Armthorpe Road, Brampton, Ontario, Canada
L6T 5M4
www.dockedge.com (800) 295-3625 Fax: 905-790-6777