NaceCare Solutions TTB1620T - Manuel (Page 20)

20
Filling the clean water tank
The TTB 1620 T is equipped with a large capacity clean-water tank allowing, for large areas to be covered in a
single fill.
To fill the clean-water tank, extend the hose located to the rear of the machine in the centre of the removable filler cap,
(Fig 13). Pull out hose, (Fig 14). Open the stopper (Fig 15) and place hose under water tap, or use a hose to
commence filling, (Fig 16).
Or the tank can be filled by unscrewing the filler cap and using a bucket or similar container (Fig 17).
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.
Fig 16
Fig 13
Fig 15
Fig 14
Fig 17
The water level in the
clean water tank can
be measured using the
scale on the left rear
side of the machine
(Fig 18).
The clean water
bottom tank holds
16 US Gall
Fig 18
Fill-level indicator
Machine Set Up