NaceCare Solutions TTB1620T - Manuel (Page 19)

19
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
! !
Fitting the floor-tool
Lower the floor-tool by moving the release lever to the lower position (Fig 7).
Push floor-tool onto the holder and secure with the easy-fit securing pin (Fig 8).
Push floortool hose onto the floor-tool; ensure hose is pushed down fully (Fig 9).
Note: Raise floor-tool again before driving to the cleaning area (Fig 10).
!
Fig 8
Fig 10
Fig 9
Fig 7
Machine Set Up
Fitting the brush
Featuring the new OBS (Octagonal Brush System);
The brushes simply push-fit up onto the chucks making fitting and removal a simple process.
Slide the brush under the brush deck (fig 11).
Fit the brush onto the OBS drive chuck (fig.12)
Safety gloves are recommended for the changing of used brushes.
Fig.11
Fig.12
Use either a 20” Brush or a 20” Pad