Napoleon Fireplaces GDI44 - Manuel (Page 13)

13
W415-0734 / D / 02.03.12
4.3 LOG PLACEMENT
POSITIONING THE LOGS IMPROPERLY WILL CAUSE FLAME IMPINGEMENT AND CARBONING.
CENTRE
SUPPORT LOCATING PIN LOCATING PIN
B A
C D
The rear log should be centred on the log support
and rest against the rear wall. Log #3 rests against the far left grate post and onto
the locating pin on the centre support. Log #2 rests
against the far right grate post and over the locating
pin on the centre support and against the tip of log #3.
NOTE: Skewering log#2 onto the locating pin may
be necessary.
Log (#6) has a leg that fi ts into an indentation on the
top of log (#3). Log (#4) rests in the indentations on
the tops of logs (#2) and (#1). Logs (#5) and (#7) fi t onto the indentations of the
lower logs.
1
2
3
6
4 7
5
!
WARNING
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
76.1A
4.4 GLOWING EMBERS
Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of
logs (#2 & #3). Care should be taken to shred the embers into thin, small irregular pieces as only the exposed
edges of the fi bre hairs will glow. The ember material will only glow when exposed to direct fl ame; how-
ever, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER
TM
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZER TM logs available
from your Napoleon® dealer.