Napoleon Fireplaces NPI45 - Manuel (Page 37)

W415-0702 / B / 04.04.12
37
THE FRONT OF THE APPLIANCE BECOMES VERY HOT DURING OPERATION. LET THE APPLIANCE
COOL COMPLETELY BEFORE CONDUCTING SERVICE.
!
WARNING
10.0 MAINTENANCE
10.1 DAILY (WHENEVER USING THE APPLIANCE)
40.2
Ashes should be placed in a metal container with a tight fi tting lid. The container should be placed on a non-
combustible fl oor, well away from combustible materials, pending fi nal disposal. If ashes are disposed of by burial
in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders are thoroughly
cooled.
When burning, the fl ames should be bright orange with embers jumping from the
burn pot. If not see “MAKE SURE PELLETS ARE NOT PILING UP” or “CLEANING
THE BURNPOT” sections.
40.3A
A. Open the side doors on either
side of the appliance.
B. On the right side of the appliance
are two latches, release the
latches by pulling the rear handle
forward and disengaging the hook
from the door frame.
C. Swing open the viewing door.
Latch
Side
Door
6.1
If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated
surfaces before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean.
If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes on
the plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room
temperature but this can be improved if the assembly is warmed, using a hair dryer or similar heat
source.
10.1.1 OPENING MAIN DOOR
10.1.2 DISPOSAL OF ASHES
10.1.3 INSPECT THE BURN POT
10.1.4 CARE OF PLATED PARTS