Napoleon Fireplaces NPI45 - Manuel (Page 29)

W415-0702 / B / 04.04.12
29
!
WARNING
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
75.2
5.5 REAR TO TOP VENT CONVERSION INSTRUCTIONS
NOTE: The insert is factory shipped in a rear vent confi guration. Be careful not to damage the gasket.
If installing 4" diameter vent vertically, it will be necessary to start with a 12" section of 3" diameter vent to clear
the hopper, then increase to 4" diameter vent.
A. To vent exit vertically, remove the two screws holding the
exhaust cover.
B. Remove the two screws holding the exhaust tube.
C. Attach the exhaust tube and gasket in the vertical position.
D. Attach the exhaust cover and gasket over the horizontal exit.
6.0 FINISHING
6.1 INSTALLING VIEWING DOOR
The main viewing door has been boxed separate from the appliance, but MUST be installed before burning
the appliance.
A. Open both side panels, exposing the bushing on the left and the latches
on the right.
B. Align the pins on the door to the bushing on the left side of the
appliance. Lower into place until both bushings touch.
C. Engage the latch hooks into the door frame. Snap the rear handle hook
to lock the latch closed.
INSERT ILLUSTRATED