Samlex America SEC-2415UL - Manuel (Page 17)

16 | SAMLEX AMERICA INC. SAMLEX AMERICA INC. | 17
seCtIOn 7 | Internal Fuse ratings & specifications
Both the AC side and DC sides have fuses that are located inside the charger. Disconnect
the AC power when checking or changing the fuses. Open the charger as follows:
1. Remove the 4 screws on the ammeter side of the top cover
2. gently slide the top cover out by about 2 to 3 inches.
(cAUtion! the top cover will be restrained from fully sliding out by the wires
connecting the ammeter , leD and fan)
3. The fuses will now be accessible
Fuse Ratings Table
FUSe RAtingS Sec-1215Ul Sec-1230Ul Sec-2415Ul
120 VAC INPUT 4A / 125V 8A / 125V 8 A / 125V
DC OUTPUT 20A / 32V 2 x 20A / 32V 2 x 10A / 32V
230 VAC INPUT 2A / 250V 4A / 250V 4A / 250V
DC OUTPUT 20A / 32V 2 x 20A / 32V 2 x 10A/32V
Specifications Table
SPeciFicAtionS
Sec-1215Ul Sec-1230Ul Sec-2415Ul
Nominal Input Voltage (pre-set) 120 VAC, 60 Hz,
3.3A 120 VAC, 60 Hz,
6.5A 120 VAC, 60 Hz,
6.5A
Internal Jumper Change 230 VAC, 50 Hz 230 VAC, 50 Hz 230 VAC, 50 Hz
Input Frequency 50 - 60 Hz 50 - 60 Hz 50 - 60 Hz
Output Voltage, Boost 1,2 14 VDC, or 14.4
VDC or disabled 14 VDC, or 14.4
VDC or disabled 28 VDC, or 28.8
VDC or disabled
Output Voltage, Float 1 13.5 VDC 13.5 VDC 27.0 VDC
Output Amps 15A 30A 15A
Operating Temperature Range 0 - 40°C 0 - 40°C 0 - 40°C
Weight 2.2 kg. / 4.8 lbs. 2.9 kg. / 6.4 lbs. 2.9 kg. / 6.4 lbs.
Housing Dimensions
(L x W x H) Inches / Millimetres 8.5 x 8.4 x 3.3 /
218 x 214 x 83 10.8 x 8.4 x 3.3 /
280 x 214 x 83 10.8 x 8.4 x 3.3 /
280 x 214 x 83
Protections Short Circuit
Overload Short Circuit
Overload / Over
Temperature Short Circuit
Overload / Over
Temperature
Output Banks 3 3 3
Safety Compliance i) Conforms to ANSI/UL STD 1564
ii) Certified to CAN/CSA STD C22.2 No. 107.2
EMI Compliance FCC Part 15(B), Class B
1. Voltages based on battery temperature of 80° F
2. Based on selection by DIP SWITCH. See pages 8 & 9
Specifications are subject to change without notice.
4004711