Doro NEOBIO 10 - Manuel (Page 8)


English
System settings
System PIN is 0000 on delivery.
1. Press . Scroll to BS SETTINGS . Press OK .
2. Scroll to desired function. Press OK .
3. Enter the desired setting. Press OK .
BS RINGER/ �he base unit’s ringer signal can be
RING VOLUME adjusted. Only applies to NeoBio 15r/25r.
DELETE HS Warning: �o de-register a handset: WARNING, A deregistered handset can not be used with
the system.
DIAL MODE �ONE/PULSE, should normally be set to TONE .
FLASH TIME RECALL �IME.
LONG =New Zealand. MEDIUM =�rance/Portugal. SHORT =others incl. UK/AUS.
CHANGE PIN �he code(e.g. 0000) can be changed.
Expanded system (Two or more handsets e.g +1...)
�he call number for internal calls will be shown in the display in standby mode. �he base unit should be
positioned centrally so that the coverage area is roughly equal for all handsets.
Intercom / internal call
1. Press (right menu button).
2. If using more than 2 handsets: Enter call number
1
-
6
for the desired handset or press
9
for all.
A tone will be heard if an external call comes in while an internal call is in progress. End the internal call
with
L
and then answer the external call with
q
.
Transferring calls/Conference between handsets
When an external call is connected;
1. Press . Scroll to INTERCOM . Press OK .
2. If using more than 2 handsets: Enter call number
1
-
6
for the desired handset or press
9
for all.
3. �o transfer: press
L
,
�or conference: hold
*
pressed down.
Register a new handset
All handsets included in the package are already registered to the base unit. Only for separate handsets/
service measures. You can register up to 6 handsets to one base unit.
This model is GAP (Generic Access Profile) compatible, which means that the handset and the base unit can
both be used with most other GAP compatible units irrespective of manufacturer. However the GAP protocol
cannot guarantee that all functions may be accessed. Extra handsets will not be available as accessories.
1. Hold down
J
(base unit) until indicator flashes.
2. Press . Scroll to REGISTRATION . Press OK .
3. Enter the base unit’s PIN code (e.g. 0000). Press OK .
4. If the registration is successful the unit will return to standby mode within one minute.