Answer machine settings, Remote activation – Doro NEOBIO 10 Manuel d'utilisation
Page 11
English
Out of memory
�he memory has room for up to 59 messages (including the outgoing message) max. 15 minutes (the
NeoBio 15r) or 30 minutes (the NeoBio 25r) depending on the compression you set. When
TAM FULL
is
shown or the base unit flashes
FF
, no new messages can be recorded until the old ones have been played
back and deleted. In that case, the telephone answer machine responds with the outgoing message for
Answer Only.
PLEASE NOTE!
Remember to delete messages regularly!
Answer machine settings
1.
Press . Scroll to
ANS. MACHINE
. Press
OK
.
2.
Scroll to
TAM SETTINGS
. Press
OK
.
3.
Scroll to desired function. Press
OK
.
4.
Scroll to desired setting. Press
OK
.
ANSWER MODE
Choose between
ANSWER & REC
and
ANSWER ONLY
(caller cannot leave message).
TAM LANGUAGE
Select language for pre-recorded outgoing message. �o activate this, press
C
(right menu
button) during playback of outgoing message.
OGM SETTINGS
Record/listen to outgoing msg.
ANSWER DELAY
Select after how many rings (2,4,6,8, time saver*) the call will be answered.
RECORD TIME
Select maximum recording time for each msg.
REMOTE ACC.
Select remote access off/on.
COMPRESSION
Higher compression gives longer recording time but reduced sound quality, LOW = best
sound quality but about half memory capacity.
BS SCREENING
Enable/disable the function in base unit which is described in chapter Screening.
CHANGE PIN
Change remote access code (0000).
The Time Saver function answers calls after six ring signals, until the first new message has been registered
- then the answer machine switches to answering after approximately two signals. This is useful when using
remote access; if you call up the answer machine and there is no reply after four rings that means there are no
messages recorded and you can hang up before you are charged for the call.
Remote activation
�he answer machine can be activated via the remote access functions.
1.
Call the answer machine. It will answer after approximately 10 rings.
2.
Press
*
when the outgoing message is played.
3.
Enter the PIN code, see
Answer machine Settings
. One beep confirms correct code.
4.
Press
7
.
5.
Replace the handset.