Dacor IF36RNBOL - Manuel (Page 12)

10
Installation Requirements
Custom Handles
Dacor recommends handles with larger D-style pulls. If using
screws with thick heads, they must be countersunk into the panel
before installing the handles.
Any handle designed for use with an appliance should produce
satisfactory results. Mounting screw length varies with the total
thickness of the panels.
IMPORTANT: Dacor does not advise the use of single pull knobs.
A. Countersunk screw
Trim frame
surrounding door
B. Handle
C. Door panel assembly
Door
B
A
C
20" Typ.
(50.8 cm)
36" Max.
(91.4 cm)
Custom Panels and Handles - IF36 Series Models (Continued)
Custom Panels Construction Information
See page 9 for overall dimensions.
NOTE: Spacer panels must be at least 1” (2.54 cm) from the top,
bottom, and side edges of the backer panel.
3-Piece Grille Overlay Panel Configuration
3-Piece Door Overlay Panel Configuration
1-Piece Overlay Panel Configuration
In some cases, your cabinet manufacturer may choose to work
with one panel routed for the different dimensions. Follow these
panel dimensions and placement instructions to be sure that the
custom overlay panels will fit properly.
w e i V e d i S w e i V p o T
A. Offset dimension
B. 1 /
4
" (6.25 mm) Backer panel
C. 1 /
8
" (3.18 mm) Spacer panel
D. 3 /
4
" (1.92 cm) Decorative
overlay panel
1"
(2.54 cm)
D
C
B
A
A. Offset dimension
B. 1 /
4
" (6.25 mm) Backer panel
C. 1 /
8
" (3.18 mm) Spacer panel
D. 3 /
4
" (1.92 cm) Decorative overlay panel
1 "
(2.54 cm)
D A C B