Danby PREMIERE DPAC12010H - Manuel (Page 4)

The power cord supplied with this air conditioner contains a device that senses damage to
the power cord. To test if your power cord is working properly, you must do the following:
Your Kenmore appliance is designed to be highly efficient in energy savings. Follow
these recommendations for greater efficiency.
1) Select a thermostat setting that suits your
comfort needs and leave at that chosen setting.
2) The air filter is very efficient in removing
airborne particles. Keep the air filter clean at all
times.
3) Use drapes, curtains or shades to keep direct
sunlight from penetrating and heating room, but
do not allow drapes or curtains to obstruct the air
flow around the unit.
4) Start your air conditioner before the outdoor air
becomes hot and uncomfortable, to avoid an initial
period of discomfort while the unit is cooling off the
room. Use of the automatic start/stop programmable
TIMER feature can be a major asset in this regard if
utilized to the fullest extent.
5) When outdoor temperatures are cool enough, turn the
air conditioner off and use the FAN MODE on High,
Medium or Low. This circulates indoor air,providing
some cooling comfort while utilizing less electricity.
NOTE: The power cord supplied with this air
conditioner contains a current leakage detection device
designed to reduce the risk of fire. In the event the
power supply cord is damaged, it cannot be repaired
and must be replaced with a new cord from the product
manufacturer.
• Under no circumstances should this device be used to
turn the unit on or off.
• The “RESET” button must always be pushed in
(engaged) for correct operation.
• The power supply cord must be replaced if it fails to
reset when the “TEST” button is pushed in.
1) Connect the power supply cord to an electrical outlet.
2) The power supply cord has two buttons located on
the head of the plug. One button is marked
“TEST”, and the other is marked “RESET”. Press
the “TEST” button; you will hear a click as the
“RESET” button pops out.
3) Press the “RESET” button; you will hear a click
as the button engages.
4) The power supply cord is now energized and
supplying electricity to the air conditioner (on
some products this is also indicated by a light on
the plug head).
3
IMPORTANT SAFETY INFORMATION
POWER
SUPPLY CORD
ENERGY-
SAVING TIPS
www.sylvane.com 1-800-934-9194