Danby SILHOUETTE DPAC120061 - Manuel (Page 18)

Remote Control Operating
Instructions
1. Sending Signal: The remote control must be
aimed directly at the infra-red eye located below
control panel when initiating a command. When
the remote control is switched on and a button is
pressed, a beep will sound (main unit) confirming
a signal was sent/received. All program selections
appearing in the remote control display will appear
in the display of the main unit when both units are
operational. If the main unit does not respond to
the command issued, try the procedure again.
If the main unit again fails to respond;
Check the following:
• Are the receiver and the remote unit within the
required 7 meter (23 ft.) operating distance?
• Is the receiver window on the main unit partially
blocked and/or obscured?
• Are the batteries correctly installed inside the
remote (positive+ / negative-)?
• Check the batteries. If low, replace.
2. Setting/Adjusting Time of Day Clock
(Remote Control): When the batteries are first
installed, the clock display flashes “0:00”. Press
the M (minute) button to set the correct time in
minutes. Each time the M button is pressed the
time is increased in 10 minute increments. The
time sets automatically (stops flashing) after 5
seconds. Press/hold the H (hour) button to
select/change the correct hour time. (time flashes)
Each time the H button is pressed the time will
increase in 1 hour increments. The time
automatically sets (stops flashing) after 5 seconds.
When the main unit is swithed on using the remote
control, the time on the main unit will automatically
adjust to the time set on the remote control.
3. Mode Setting: Press the “Mode” button to select
operating mode. Each time the button is pressed
will advance to a different setting i.e
Auto–Cool–Dry–Fan.
4. Temperature Setting: Press the remote
buttons to select the desired
C/F operating temperature.
Each time a button is pressed the
temperature will increase/decrease 1°C/F. The
temperature selected will appear in the remote
display.
When the main unit is switched on using the
remote control, the temperature on the main unit
will automatically adjust to the temperature set
on the remote control. Temperature ranges from
16°C-31°C (60.8°F ~ 88°F)
5. Fan Speed Setting: Press the
“Fan” button to select the operating fan speed.
Depending on the mode selection, the fan button
will advance to a different fan speed
(Auto–Low–Medium –High)
The fan speed selected will appear in the
display window.
FAN SPEED ICONS
LOW MEDIUM HIGH
MODE AVAILABLE FAN SPEEDS
Cool Low–Medium–High
Dry Low
Fan Low-Medium-High
AUTO Low–Medium–High
17
3
6
Timer On/Off
LCD Window
MODE ICONS
DRY COOL FAN