DCS 221712 - Manuel (Page 9)

7
BEFORE INSTALLING HOOD
TYPICAL INSTALLATION
A typical hood installation is shown below in Figure 1. When installed with the IVCK chimney
accessory kit, the hood can be installed at a height of 30” to 36” in kitchens with ceiling heights
ranging from 8-1/2 to 10 feet. Installatons outside this range will require custom framing. Consult a
qulified installer for a custom framing solution.
DUCTING
Provide a 10” Round Duct. Ducting run cannot exceed 40 feet, including allowance for elbows/tran-
sitions.
ELECTRICAL
Install a 1/2” conduit from the service panel long enough to reach the hood once it is installed.
Power supply must be rated for 120V 60Hz, 15 amps (minimum).
INSTALLATION HEIGHT CALCULATIONS
See Figure 1.
a) Select a hood installation height C that is comfortable for the user. (30”to 36”
recommended, 30” minimum).
b) Calculate chimney cover height E using fomrula below.
Save this calculation for use later in the installation.
A = Kitchen Ceiling Height
B= Counter Height (36" standard)
C= Installation Height of Hood.
D= Canopy Height = 13”
E= Chimney cover height = A – B – C – D
NOTE: Chimney cover height can be adjusted
from 24-1/2" to 36" to meet your desired
hood installation height.
FIG.1
A
B
C
D
E