Danby Premiere DPAC 11010 - Manuel (Page 4)

READ ALL SAFETY INFORMATION BEFORE USING
1) All wiring must comply with local and national electrical
codes and be installed by a qualified electrician. If you have
any questions regarding the following instructions, contact a
qualified electrician.
2) Check available power supply and resolve any wiring
problems BEFORE installation and operation of this unit.
3) This appliance draws 10.8 nameplate amps under Cooling
Mode and may be used in any properly wired, general purpose
15 amp household grounded receptacle.
4) For your safety and protection, this unit is grounded
through the power cord plug when plugged into a matching
wall outlet. If you are not sure whether the wall outlets in your
home are properly grounded, please consult a qualified
electrician. DO NOT USE PLUG ADAPTERS OR
EXTENSION CORDS WITH THIS UNIT. If it is necessary to
use an extension cord with this unit, use an approved “air
conditioner” extension cord only (available at most local
hardware stores).
5) The manufacturers nameplate is located on the rear panel of
the unit, and contains electrical and other technical data
specific to this unit.
6) To avoid the possibility of personal injury, always
disconnect the power supply to the unit before installing
and/or servicing.
TABLE 1
Suggested Individual Branch Circuit
Nameplate Amps *AWG Wire Size
10.8 16
AWG- American Wire Gauge
*Based on copper wire at 105°C temperature rating.
TABLE 2
Receptacle and Fuse Types
Rated Volts 125
Amps 15
Wall Outlet
Fuse Size 15
Time Delay Fuse Plug Type
(or Circuit Breaker)
Control Panel
Handle
Hole
Castor
Signal
receptor
Air outlet
Air intake
(evaporator)
Air outlet
hose
Power supply cord Water outlet drain
Air intake
hose
ELECTRICAL
SPECIFICATIONS
CAUTION: Do not leave this unit
unattended in a space where people or
animals cannot react to a failed unit are
located. A failed unit can cause extreme
overheating or death in such an enclosed,
unattended space.
3
UNIT PARTS IDENTIFIED
IMPORTANT SAFETY INFORMATION