Laerdal SimJunior Advanced - Manuel (Page 15)

13
Sim
ulation Softwar
e
Sim
ulator Setup
Maintenance
Spar
e Par
ts
Specifications
Intr
oduction
Tr
oubleshooting
Maintenance
Opening the Torso
Open the Simulator torso to perform procedures such as:
– Attaching or replacing limbs
– Replacing the Simulator Battery
– Replacing the Chest Rise Bladder and Lung Bladder
– Replacing the Torso Skin
– For general inspection
Warning: Open the torso from left to right, gently unhook the
skin. Do not pull hard to lift the Torso Skin, this could damage
the chest cables.
1. Unhook Torso Skin holders on left side of the torso and each
shoulder.
Replacing the Simulator Battery
1. Open the Simulator torso.
2. Fold the Torso Skin over to the right side.
3. Disconnect the Defibrillation connector cable.
4. The Defibrillation connector cable must be disconnected at the
right side of the Simulator below the chest form.
Note: DO NOT disconnect the tubes and cables connecting
the stomach foam to the Simulator.
5. Replace the Torso Skin by performing steps 1- 4 in reverse.
2. Slide the battery out of the battery strap.
3. Pull the battery power connection up from inside the
Simulator. Unhook the battery power connection.
4. Lift the battery out of the Simulator.
5. Replace the charged battery or install a new Laerdal
approved SimJunior battery.
6. Connect the battery to the Simulator.
7. Replace the Torso Skin.