Levana LV-TW502 - Manuel (Page 12)

12
Note: When the battery power is low, the power LED will FLASH RED indicating LOW BATTERY. Once
the power plug has been inserted, the power LED will turn GREEN to show it is charging.
SETTING UP YOUR SYSTEM
Installing the Rechargeable Battery
1. Turn the belt clip on the back of the monitor
unit upwards.
2. Remove the battery compartment cover
using a flat edge screwdriver to twist the
battery compartment latch to the open
position.
3. Insert the included rechargeable battery,
ensuring that the copper connections on the
battery line up with the copper connections
on the inside of the battery compartment.
4. Replace the battery compartment cover and
use a flat edge screwdriver to tighten the
latch to the locked position.
Charging the Monitor and Rechargeable Battery
1. To charge the battery in the monitor unit, plug the included power adapter into the
power input jack on the right side of the monitor.
2. The power LED will light up GREEN to indicate that the battery is CHARGING.
3. The power LED will light up to a SOLID RED once the battery is FULLY CHARGED.
4. For safety reasons, use ONLY the adapters included in the package.
Copper Connections
Switching the Camera ON/OFF
Position the camera to view the area you wish to monitor, angle the camera
lens for best view, by turning it up or down.
1. Slide the power switch
to the ON position.
2. The Power LED on the front of the camera will light up green. The
camera is now ready to operate.
3. To turn OFF the camera, flip the power switch back to the OFF
position.
CAMERA OPERATION