GE JGP329DETBB - Manuel (Page 4)

Installation Instructions
PREPARING THE OPENING
[Ü MAINTAIN THE FOLLOWING
MINIMUM CLEARANCE
DIMENSIONS
13" MAX. Depth of unprotected
overhead cabinets
30" MIN. clearance from countertop
to unprotected overhead surface
3-3/4" MIN. clearance from
cutout to side wall on the
left of the unit
6"
MIN. clearance from
ci^1;out to side wall on the
/ right of the unit
18" MIN. height
from countertop to
nearest cabinet on
either side of unit
7/16"
3-5/8' NOTE: Allow 7/15"
minimum vertical
clearance from the
cooktop bottom (or 3-5/8"
minimum depth from
the countertop) to any
combustible surfaces,
such as a cabinet drawer.
For island installation, maintain 2-1/2 in. minimum
from cutout to front and back edge of countertop.
Maintain 3 in. minimum from cutoutto side edges of
countertop.
H OVERALL COOKTOP DIMENSIONS
21" (21-1/2" Max. for
Glass Top models)
\
_"^3-3/16"
19-3/8"
H CUTOUT DIMENSIONS OF
COUNTERTOP
To ensure accuracy, it is best to make a
template when cutting the opening in the
counter.
19-5/8" width cut
28
-
1
/
2
"
length^^ 14 - 1 / 4 ":
/
2-1/4" Min. Between
cutout and the wall
behind the cooktop
of cut
2-1/2" Min. from front
edge of cutout and front
edge of countertop
H RECOMMENDED GAS SUPPLY
LOCATION FROM BACKWALL
' Min. From Backwall
Recommended
gas supply
location 13-1/4"^
0 From Cutout
^
Center Line
H MAKE SURE WALL COVERINGS,
COUNTERTOP AND CABINETS
AROUND COOKTOP CAN
WITHSTAND HEAT (UP TO 200“F)
GENERATED BY COOKTOP
Wall covering,
cabinets and
countertop must
withstand heat
up to 200°F
H FOR AMERICANS WITH DISABILITIES
ACT (ADA) FORWARD APPROACH
INSTALLATION ONLY:
Aiiow 5" minimum
depth between the
countertop and an
enciosure.
NOTE: The enciosure must be mode of wood
moterioi. Aiso, on access ponei is required for the
eiectricoi outiet, pressure reguiotor, shut-off voive,
hoid-down brockets, and service.