GE JGP329DETBB - Manuel (Page 15)

Installation Instructions
H CHANGE COOKTOP BURNER
ORIFICES (CONT.)
E Locate the LP orifices attached to the
regulator along with separate LP conversion
instructions. They will have a digit for size,
and a letter for type of gas, on the top or
side. (Important: Save the orifices removed
from the appliance for future use.)
Each orifice will show a series of engraved
marks, (I, II, III, X or none), located on the top.
These marks denote the precise location of each
orifice to the cooktop burner.
X
j
V V
i
^ V
ii
^ yxy
15,000 BTU/HR Burner (on some models)
o
The 15,000 BTU/HR burner has two orifices with
markings located in the sides only. (See rating
plate on bottom of appliance).
NOTE: The main orifice is located low in the center
of the burner while the simmer orifice is located
higher behind the center of the burner.
Main orifice
JGP329
JGP333 &PGP943
JGP940
E Install the LP orifices in their precise locations
as noted in the illustrations above.
E Return the natural gas orifices to the bracket
and reattach the bracket and the instruction
sheet to the pressure regulator using the
screw removed previously.
E Replace the burner bases, heads, caps and
top grates. (NOTE: When re-attaching the
burner bases to glass top units, tighten screws
to a maximum of 10 in.-lbs torque.)
15