Panasonic NI-WL600 - Manuel (Page 9)

NOTE: Do not touch the fabric with the iron. Keep the iron slightly over the fabric to
prevent burns or disfiguring.
Jet of Steam can be provided by pumping the " Jet of Steam Button ".
Set temperature at" HIGH " level.
To avoid hot water from dripping out of the Soleplate, please give 5 seconds
of Interval time before re-pumpIng
2. Vertical Steam
To get better results when using vertical steam, hang the garment on a clothes hanger. Curtains
and drapes may also be steamed once they're hung. Hold the iron away from your body, close
to but not touching the fabric. Pull the fabric tight with your free hand and pump the Vertical
Steam Button (Jet of Steam Button) at 5 seconds Intervals as you pass the Iron over the
wrinkled fabric.
Never Iron clothes on the body or point your Iron at anyone when steaming. Hot steam can cause
skin burns. Keep hands and body away from steam areas while using vertical steam feature.
3. Anti-Drip System (Automatic Water Seal)
This model has an Anti-Drip System. When the temperature of the Soleplate's surface drops
below 250°F(121 ”C), the valve for the vaporizing chamber in the iron automatically closes
and stops the water from going in further. This prevents hot unvaporized water from ejecting
out of the soleplate when the iron has cooled down. With this System, it is unnecessary
for you to wait until the Inside of the vaporizing chamber dries completely when you store
the iron.
NOTE: It Is not a sign of malfunction when you hear a clicking sound.
This sound can be heard whenever this System Is activated.
4. Automatic Shut-Off
The Automatic Shut-Off System provides you with a visible warning signal before the Iron
automatically shuts off. The Iron will automatically shut Itself off If It has been left on the
Power Base longer than 10 minutes. Ten seconds before the actual shut-off, the "OFF"
indicator will start blinking rapidly.
If the Iron Is not moved during the warning, the heater In the iron's Soleplate will automatically
shut off.
The Automatic Shut-Off System activates only after the temperature reaches Its selected level.
To reheat your iron after it automatically shuts off, simply push " SET " Pad until the red light
appears at the desired temperature Indicator.
" OFF " light(green) remains on after your iron automatically shuts off.
This light indicates that the iron is still plugged Into the electrical outlet and voltage is being
supplied to the Power Base.
5. Spray
Note: Before using the spray feature, check the fabric label for ironing instructions because
some fabrics may be spotted or stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and where extra
dampening Is needed.
-9-