Panasonic NI-WL600 - Manuel (Page 3)

7. Close supervision is necessary for this appliance when used by or near chiidren.
Do not ieave iron unattended while connected to an electrical outlet or on an
ironing board. Always position iron carefully to prevent it from falling if ironing
board is accidentally bumped or if Cord is pulled. Always place iron securely
into Power Base when not in use.
8. Burns can occur from touching hot metal parts, the hot surface of the Power Base,
hot water, or steam. Use caution when you turn a steam iron upside down—there
may be hot water in the Water Tank.
9. To protect against burns or injury to persons, do not direct steam toward the
body when ironing or self-cleaning.
10. The iron must be used and rested on a stable surface. When placing the iron into
Power Base, ensure that the surface on which the Power Base is placed is stable.
11. The AC Power Cord and Plug may present
a risk of personal injury when the cord is
allowed to retract freely. Always hold the
plug and cord with one hand while it is
retracting, and retract the cord slowly to
reduce the risk of the cord "WHIPPING",
which has the potential risk of causing
injury to the face, eyes, etc..
SPECIAL INSTRUCTIONS
WARNING Instruction
Please read WARNING
before use.
O pullout5'-10cm
\
AWARNING To reduce the risk of electric
shock or fire;
1. To avoid a circuit overload, do not operate another high wattage appliance on
the same circuit.
2. If an extension cord is absolutely necessary, use a cord rated a minimum of 13
amperes. Cords rated for less amperage may overheat and should not be used.
Care should be taken to arrange the cord so that it cannot be accidentally pulled
or tripped over.
A
CAUTION To reduce the risk of personal
injury and damage to your iron;
1. Never use steam iron cleaning products in the iron, as they may damage working
parts of the iron.
2. Do not use water additives or substitute water such as linen or scented water
in the steam iron. They can stain fabrics.
3. If the Steam/Dry Selector is not in the Dry position after using, remaining water will
move into the Soleplate and can result in burns, the next time the iron is used.
4. Do not use the Steam or Jet of Steam, while AC Cord is unplugged, water will
remain inside the Soleplate which will cause staining.
Do not use Steam or Jet of Steam while Temperature Selector Dial Is set to "OFF".