Panasonic AG-TL500 - Manuel (Page 26)

'.'^'1R--1
ffroublêwith installation
No power. • Is the power plug inserted properly into the AC outlet?
No picture. • Is the unit connected properly with the TV, video cameras, etc.?
• Are any of the connecting cables making faulty contact?
Indistinct picture. ‘ Has the focus on the video cameras been adjusted correctly?
i Troubfc
}
with functionstor operationj
mi*-, vi# .4
Nothing happens even when operation
buttons are pressed.
• Is the video cassette loaded?
• Is the MENU/REC LOCK switch at OFF?
• Has the video cassette been inserted properly? Press the
EJECT button to eject the cassette and insert properly.
• Has INT lighted on the display?
• Has the mode lock been applied through control exercised by the
RS-232C interface?
“ d ” mark is flashing. • The unit will not operate because its safety protection function
has been triggered. Wait until the flashing disappears.
^^lncase>l.molsture*"i
-►
Ejection will remain
incomplete when a video
Wait until the" d " mark
goes out with Power switch
The " d " mark at display
cassette has been inserted. turned “ON”. It may take a
section flashes.
few hours, although it
depends upon conditions.
Date and time display data has not been
stored in memory when the power failed.
• Has the unit’s power plug been disconnected from the power
outlet for a long time?
Insert the unit’s power plug into the power outlet and supply
power continuously for at least 3 days to the unit.
Tape can be played, fast forwarded or
rewound but not recording results.
• Is the tab on the video cassette broken?
Recording has stopped. • Is the video cassette tape at its end?
Have more than 5 minutes elapsed since the PAUSE/STILL
button was pressed during recording?
Are the routine inspections being carried out? If this phenome­
non keeps recurring, it means that some failure or other is to
blame. Consult with your dealer.
The power has been restored after a
power failure but recording does not
automatically resume.
• Has the power failure lasted a long time {more than 1 week)?
Set the timer recording switch to EXT to ensure that the unit is
set to the recording mode even after a prolonged power failure.
Recording cannot be stopped. • First set the MENU/REC LOCK switch to OFF and then
operate.
• Is REC LOCK on Menu Screen 1 at OFF?
• Has the mode lock been applied through control exercised by the
RS-232C interface?
1-week programd timer recording
cannot be conducted properly.
• Are the date and time on the regular displays correct?
(See page 10)
One or more cameras do not record
when a multiple number of cameras are
used.
• Turn the time adjustment control on the frame switcher,
and adjust it to a setting which is longer than the video
recording duration in the recording time mode.
• Connect a camera switching cable between the unit and
frame switcher.
No auto repeat recording. • Has the stop button been pressed during auto rewinding?
26