Panasonic NI-L70SR - Manuel (Page 9)

NOTE:
Do not touch the fabric with the iron. Keep the iron slightly over the fabric to
prevent burns or disfiguring.
Jet of Steam can be provided by pumping the “ Jet of Steam Button ".
Set temperature at" HIGH " level.
To avoid hot water from dripping out of the Soleplate, please give 5 seconds
of interval lime before re-pumping
2. Vertical Steam
To get better results when using vertical steam, hang the garment on a clothes hanger. Curtains
and drapes may also be steamed once they're hung. Hold the iron away from your body, close
to but not touching the fabric. Pull the fabric tight with your free hand and pump the Vertical
Steam Button (Jet of Steam Button) at 5 seconds intervals as you pass the iron over the
wrinkled fabric.
3. Anti-Drip System (Automatic Water Seal)
This model has an Anti-Drip System. When the temperature of the Soleplate's
surface drops below 250T(121 *C), the valve for the vaporizing chamber in the iron
automatically closes and stops the water from going in further. This prevents hot
unvaporized water from spitting out from the soleplate when the iron has cooled
down. With this System, it is unnecessary for you to wail until the inside of the
vaporizing chamber dries completely when you store the iron.
NOTE:
It is not a sign of malfunction when you hear a clicking sound.
This sound can be heard whenever this System is activated.
4. Automatic Shut-Off
The Automatic Shut-Off System provides you with a visible warning signal before
the iron automatically shuts off. The iron will automatically shut itself off if the iron
has been left on the Power Base longer than 10 minutes. 10 seconds before the
actual shut-off, the" OFF ” indicator will start blinking rapidly.
If the iron is not moved during the warning, the heater in the iron's Soleplate
will automatically shut off.
The Automatic Shut-Off System activates only after the temperature reaches its selected level.
To reheat your iron after It automatically shuts off, simply push " SET *' Pad until the red light
appears at the desired temperature indicator.
" OFF" light(green) remains on after your iron automatically shuts off.
This light indicates that the iron is still plugged into the electrical outlet and voltage is being
supplied to the Power Base.
5. Spray
Note: Before using the spray feature, check the fabric label for ironing instructions because
some fabrics may be spotted or stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and where extra
dampening is needed.
The spray may be used with steam or dry ironing.
1. Simply pump the Spray Mist Button ,.4., whenever spray is desired. 1.
If the spray doesn't come out immediately, keep pumping until it does.
2. To get a finer spray, pump the Button vigorously.
To get a more powerful spray, pump the Button more slowly.
For best results, use a quick, full stroke. "'v
-9-