Panasonic NI-L70SR - Manuel (Page 10)

HOW TO CARE FOR YOUR IRON
AFTER EACH USE
1. Press the “ SET" Pad until the" OFF" light turns on.
2. Move the Steam/Dry Selector to Dry Position.
3. Unplug the iron, retract the cord slowly. Always hold the Plug and cord with one hand while
it is retracting.
4. Empty the water from the Water Tank. DO NOT store the iron with water inside.
5. Push the Cover Case until it clicks to lock.
O pull out 5-10 cm
\
Push the Cover
Case until you
hear a click.
MAIN BODY
1. When cleaning the main body of the iron , make sure that iron has cooled down.
2. Wipe the iron with a damp cloth If necessary, use a mild detergent.
NEVER USE ANY HARSH CLEANERS.
SOLEPLATE
' Starch and other residue can be easily removed from the Soleplate with a damp cloth.
* To avoid scratching the finish, never use a metallic pad to clean the Soleplate, and
never place the iron on a rough surface.
* If synthetics are being ironed on a higher temperature level than instructed, not only
will the fabric be ruined, but the Soleplate will often be covered with the melted remains
of the synthetic fabric.
* The best way to remove synthetic residue from the Soleplate is to iron over an old
cotton rag after heating the iron.
A CAUTION
Never use steam iron cleaners in the iron since it may cause damage to the inside of the iron.
If the Power Cord is damaged, it must only be replaced by a special cord.
The iron must only be used with the Power Base provided.
SPECIFICATIONS
Model NI-L70SR
Power Source 120V~ 60 Hz
Power Consumption 12.5 A, 1500W
Net Weight 5.1 lb (2.3kg)
-10