Panasonic WV-CM2080 - Manuel (Page 7)

■ Multiple Monitor Connection
To monitor the same video on multiple monitors, connect
the VIDEO OUT A or B connector on the monitor to the
VIDEO IN connector of the other monitor with a coaxial
cable.
Up to 10 monitors can be connected in series before signal
loss occurs. Total cable length should not exceed 150
meters (500 feet).
■ Connection to the Standby
On/Off Terminal
Connecting an outboard device to the STANDBY ON/OFF
Terminal on the rear of the monitor enables control of the
monitor display by input from that device, both in normal
and standby display mode.
Shown below is an example of how to use this function.
■ Connection with the System
Controller
If the optional 6-conductor cable assembly is used, simply
plug one end of the cable into the DATA port of the Monitor
and the other end into the DATA port on the System
Controller.
If you use cables assembled from locally procured materi­
als, it is important that only high quality, data grade cable,
suitable for RS-485 communication (shielded 4-wire twisted
pair cable), BELDEN 9406 or equivalent, is used.
Lower grade cable will result in unstable operation of the
system.
STANDBY
ON
STANDBY
OFF
(*)
Alarm Output
Alarm Reset Output
V h ^^SV
■—V l ^O.2 V
DATA DATA
3^0 BL d
STANDBY ON input
Pulse +5 V DC
STANDBY OFF input
Non-voltage contact or open collector output
Note: To set up this function, refer to STANDBY ON in
the Display Setting menu.
P
G TA TB HA RB G
N I—J
1—1 N
D D
Setting the Termination
Set the Termination Selector located on the rear of the
monitor according to your requirements.
ON: Data is terminated.
OFF: Data is sent to other equipment.