Panasonic CQ-MRX777EUC - Manuel (Page 35)

Pre-out (External Output) Setting
Pre-out (External Output) Switching
Connect an optional power amplifier (CY-M9054EUC, for example) and set it to suit your system.
Your unit has a preout for rear output and another for Sub-woofer/front/rear output. The operating proce­
dures for the possible setting of preout {Sub-woof er/front/rear) outputs are described in this section.
• Sub-woofer output if an external amplifier or a Sub-woofer with a built-in amplifier is connected
• Through output if a system-up speaker is connected
Note:
SUB-W and THRU cannot be used at the same time.
Sub-woofer Output (SUB * W) Mode Setting
• The SUB-W indicator blinks during adjustment and lights steadily when the mode is set.
Note:
• Sub-woofer output is monaural and does not change even if the volume balance of the built-in ampli­
fier is adjusted. (See Fader, page 28.)
• In Sub-woofer output mode, BAL/FAD, POSITION, SBC/SBC-SW, DRCII and SPACE effects are
invalid.
Selecting a Sub-woofer Output
Setting Item
© Press and hold SPC(SUB-W) for more than 2 seconds to change to
the preout setting mode.
® Press VOLV to display “PREOUT SUB-W’.
■Z- Press V when using a remote control.
© With Sub-woofer output selected, press SPC(SUB-W) to change to
the SUB -W mode as follows.
LEVEL SELECT: Volume Adjustment
I
DELAY SELECT: Delay Time Adjustment
I
FREQ SELECT: Setting Cutoff Frequency
Note:
When a setting mode is selected but no operation is made within
5 seconds, the display will return to the regular operation mode.
CQ-MRX777EUC
33