Sony XR-5550 - Manuel (Page 21)

pecifications
audio po
W
er specifications
POWER OUTPUT AND TOTAL HARMONIC DISTORTION 10 watts
per channel minimum continuous average power into 4 ohms, both
channels driven, from 30 to 20,000 Hz with no more than 1% total
harmonic distortion.
Other Spepifications
Power amplifier section
Outp jts Speaker outputs (sure seal
connectors)
Speaker impedance 4-8ohms
Maximum power output
20 W X 4 (at 4 ohms)*
• Measured at 14.4 V
Casiiette player section
Tape track 4-track 2-channel stereo
Frequency response 30 -16,000 Hz
Signiil-to-noise ratio
Cassette type Dolby B Dolby NR off
TYPE II, IV 68 dB 58 dB
TYPEI 63 dB 55 dB
Wow and flutter 0.13% (WRMS)
Tunor aection
Systi-m Superheterodyne tuner
computerized quartz-kxrked
synthesizer system
Anterrna terminal External antenna connector
FM
Tunirig range 87.9-107.9 MHz
Intennediate frequency
10.7 MHz
Usable sensitivity 12 dBf (75 ohms)
Selectivity 75 dBf at 400 kHz
Signtil-to-nc^ rabo 65 dB (stereo), 70 dB (mono)
Hartronic distortion at 1 kHz
0.5% (stereo), 0.3% (mono)
Separation 35dBat1 kHz
Frequency response 30-15,000 Hz
Capture ratio 2dB
AM
Tuning range 530-1,710kHz
Intermediate frequency
450 kHz
SensitMtv 35 uV
General
Tone controls
Loudness
Output lead
Bass ±8 dB at 100 Hz
Treble ±8 dB at 10 kHz
+6 dB at 100 Hz
+6 dB at 10 kHz
Power antenna relay control
Power amplifier control lead
Power requirements l2VDCcar battery (negative
ground)
Dimensions Approx. 186x57x170 mm
(w/h/d)
(7%x2V<X6*A in.)
not incl. projecting parts and
controls
Mounting dimensions Approx. 182x53x154 mm
(w/h/d)
(7'/4X2'/i»x6'/kin.)
not incl. projecting parts and
controls
Weight Approx. 1.3 kg (2 lb. 14 oz.)
Accessories supplied Mounting hardware (1 set)
Power connecting cord (1)
Front panel case (1)
Design and spedfications subject to change without
notice.