Sony MDS-JE320 - Manuel (Page 9)

Notes on Recording
If ‘Protected' appears in the display
The MD is record-protected. Close the slot to record
on the disc (see "To protect an MD against accidental
erasure" on page 7).
If 'Din Unlock' flashes in the display
• The digital program source is not cormected
properly.
To continue, connect the program source properly.
• The program source is not on.
Turn on the program source.
Depending on source being recorded, track numbers
are marked in following ways:
• when recording from a CD or MD with INPUT set to
DIGITAL and the source cormected through the
DIGITAL OPTICAL IN connector:
The deck automatically marks track numbers in the
same sequence as the original. If, however, a track is
repeated two or more times (e.g. by single-track
repeat play) or two or more tracks with the same
track number (e.g. from different MDs or CDs) are
played, the track or tracks are recorded as part of a
single, continuous track with a single track number.
If the source is an MD, track numbers may not be
marked for tracks of less than 4 seconds.
• When recording from source cormected through
LINE (ANALOG) IN with INPUT at ANALOG, and
"LEVEL- SYNC" does not light up (see "Marking
Track Numbers While Recording" on page 12) er
when recording from a DAT or satellite broadcast
cormected through the DIGITAL OPTICAL IN
cormector with INPUT set to DIGITAL:
The source will be recorded as a single track.
If "LEVEL-SYNC" appears in the display, the deck
automatically marks track numbers when recording .
analog source or digital recording of DAT or a
satellite broadcast (see "Marking track numbers
automatically" pn page 12).
• when recording from DAT or satellite broadcasts
with INPUT set to DIGITAL, the deck automatically
marks a track number whenever the sampling
frequency of the input signal changes.
V You can mark track numbers during or after
recording
For details, see "Marking Track Numbers While
Recording" (page 12) and "Dividing Recorded Tracks"
(page 19).
When ‘TOC flashes in the display
- The deck is currently updating the Table Of Contents
(TOC). Do not move the deck or pull out the AC power
cord. Changes to an MD made through recording are
saved only when you update the TOC by ejecting the
MD or changing the deck to standby by pressing the
I / (!) switch.
The MD deck uses the SCMS (Serial Copy
Management System on page 27)
MDs recorded through the digital input cormector
cannot be copied onto other MDs or DAT tapes
through the digital output cormector.
QEN