Sony MDS-JE630 - Manuel (Page 55)

Menu item Sub-item Function Parameters Factory
setting Reference
page(s)
Pitch — Changes the playback speed by auto steps. -t8 to +2 0 41
Pfine — Fine controls the playback speed. -98.5 to +12.5'X, o.o*;-;. 41 [
Ain — Adjusts the analog signal level input through
the LINE (ANALOG) IN jacks. ^ to +12.0dB O.OdB 17
Optl — Adjusts the digital signal level input through
the DIGITAL OPTl connector. to +18.0dB O.OdB 17
1
Opt2 — Adjusts the digital signal level input through
the DIGITAL OPT2 connector. -oo to +18.0dB O.OdB 17
Août ' Adjusts the analog signal level output to
the LINE (ANALOG) OUT and PHONES jacks. -20.2 to O.OdB O.OdB 24
Sleep — Sets the duration of Sleep Timer. 30/60/90/120min 60min 42 i
Sleep — Turns Sleep Timer on or off. On/Off Off 42
Keyboard ? Type Selects the type of the keyboard connected to the deck. US/JP US 45
Assign ? Assigns a character to the keyboard connected to the deck. — — 48 1
To recall a factory setting
Press CLEAR while selecting the parameter.
Self-Diagnosis Function
The deck's self-diagnosis function automatically checks the condition of the MD deck when an error occurs, then issues a
three-digit code and an error tnessage on the display. If the code and message alternate, find them in the following table
and perform the indicated countermeasure. Should the problem persist, consult your nearest Sony dealer.
Three-digit code/Message Cause/Remedy
Cll/Protected The inserted MD is record-protected.
^ Take out the MD and dose the record-protect slot (page 16).
C13/REC Error The recording was not made properly.
^ Set the deck in a stable surface, and repeat the recording procedure.
The inserted MD is dirty (with smudges, fingerprints, etc.), scratched, or substandard in quality.
^ Replace the disc and repeat the recording procedure.
C13/Read Error The deck could not read the TOC on the MD properly.
^ Take out the MD and insert it again.
C14/Toc Error The deck could not read the TOC on the MD properly.
^ Insert another disc.
^ If possible, erase all the tracks on the MD (page 32).
C71 /Din Unlock The sporadic appearance of this message is caused by the digital signal being recorded. This will not affect
the recording.
While recording from a digital component connected through the DIGITAL IN connector, the digital
connecting cable was unplugged or the digital component turned off.
Connect the cable or turn the digital component back on.
> a
a
H-'
o'
3
SL
3
0
3
u
I*
o'
3
55^