Tweco 20 O2 Auto-Cut - Manuel (Page 81)

Manual No. 0-4816 Auto-Cut 200
2
4-15 OPERATION
Status
Code
5-1 CANBUS Failure to
Acknowledge fault. If GCM 1000, Basic ID signal missing; Other gas controls, Fiber
disconnected or broken, Transceiver (what fiber plugs into) fault, replace
Gas control PCB or CCM
CANBUS Off due to
excessive data errors;
CANBUS data error warning.
Errors increasing, will soon
fault.
5-4 CCM Message not sent Dirt on fiber ends or in connectors, blow out with clean dry air; fiber not
locked into connector; sharp bends in fiber; fiber defective; CANBUS
hardware error (CCM or Gas Control PCB)
6-1 CCM Analog Voltage Error Replace CCM
6-2 CCM ADC or DAC error Replace CCM
Torch coolant tube broken or missing;
CCM fault, replace CCM
6-4 CCM Data Memory error Replace CCM
Status Code Key (cond)
Message Cause/Remedy
5-2 Dirt on fiber ends or in connectors, blow out with clean dry air; fiber not
locked into connector; sharp bends in fiber; fiber defective;
5-3 Dirt on fiber ends or in connectors, blow out with clean dry air; fiber not
locked into connector; sharp bends in fiber; fiber defective;
6-3 Coolant Flow too High error,
flow > 2.7 gal/min