Rockwell Automation 2080-PS120-240VAC Micro800 Programmable Controllers External Power Supply - Manuel (Page 9)

Micro800™ Programmable Controller External AC Power Supply 9
Publication 2080-IN001A-EN-P - September 2010
DIN Rail Mounting
Use a flat-blade screwdriver to mount the power supply on EN50022-35x7.5
DIN rails.
Panel Mounting
The preferred mounting method is to use four M4 (#8) screws per module.
Hole spacing tolerance: ±0.4 mm (0.016 in.).
Follow these steps to install the power supply using mounting screws.
1. Place the power supply against the panel where you are mounting it.
Make sure the power supply is spaced properly.
2. Mark drilling holes through the mounting screw holes and mounting
feet then remove the power supply.
3. Drill the holes at the markings, then replace the power supply and
mount it.
Leave the protective debris strip in place until you are finished wiring
the power supply and any other devices.