Swiss+Tech Screwz-All 7-in-1 - Manuel

Made in China. SCREWZ-ALL ® is a registered
trademark, and MMMMMMMMI ™ and MI ™ are
trademarks of Swiss+Tech Products. Specifications
are subject to change without notice.
©2012 Swiss+Tech Products, Solon, OH 44139 USA
This product contains button batteries.
IF SWALLOWED, batteries could cause
severe injury or death in just 2 hours.
SEEK MEDICAL ATTENTION IMMEDIATELY.
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and -).
• Remove used batteries promptly.
• Replace all batteries of a set at the
same time.
BATTERY WARNINGS:
Limited LIFETIME Warranty
This product is covered by a Limited Lifetime Warranty
to the original purchaser in that this product is free from
defects in workmanship and materials. During the
warranty period, this product will either be repaired or
replaced with a product of equal or greater value,
excluding any custom engraving or printing.
Damage through normal wear and tear (including
battery expiration and surface coatings), repair or
alteration, misuse, abuse, neglect, accident, improper
storage and handling, fire, negligence, improper
cleaning, circumstances not directly attributable to
manufacturing defects, or act of God is not included.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED
TO, IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR USE.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state. Simply return your SWISS+TECH ® brand product
postpaid and insured to:
Swiss+Tech Products
30725 Solon Industrial Pkwy
Solon, OH 44139 USA
www.swisstechtools.com
1-800-414-8799
ST74124
Screwz-All
®
7-in-1
Battery Replacement
1. Open tool and lay on flat surface as shown.
2. Loosen captive screw (it remains in battery
cover to prevent loss), remove battery cover.
3. Remove old batteries.
4. Replace with 2 new CR1216 3V lithium
batteries or equivalent, between bulb wires,
with positive (+) side up.
5. Replace battery cover, tighten screw gently.
Two CR1216 Batteries
or Equivalent,
Positive Side (+) Up
Captive
Screw
Battery
Cover
• Solid stainless
steel tools
• Open one tool
at a time
1. #1 Phillips Driver
2. #2 Phillips Driver
3. #1 Flathead Driver
4. #2 Flathead Driver
5. 1/8" Rule Markings
6. 5 mm Rule Markings
7. LED Flashlight
5
6
3
1
7
4
2
Soft-Touch
ON/OFF Button