Swiss+Tech Carabiner Micro Light - Manuel

Patent pending. Made in China. Glo-Ring™,
MMMMMMMMI ™ and MI ™ are trademarks
of Swiss+Tech Products. Specifications are
subject to change without notice.
©2012 Swiss+Tech Products, Solon, OH 44139 USA
This product contains button batteries.
IF SWALLOWED, batteries could cause
severe injury or death in just 2 hours.
SEEK MEDICAL ATTENTION IMMEDIATELY.
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and -).
• Remove used batteries promptly.
• Replace all batteries of a set at the
same time.
BATTERY WARNINGS:
Limited LIFETIME Warranty
This product is covered by a Limited Lifetime Warranty
to the original purchaser in that this product is free from
defects in workmanship and materials. During the
warranty period, this product will either be repaired or
replaced with a product of equal or greater value,
excluding any custom engraving or printing.
Damage through normal wear and tear (including
battery expiration and surface coatings), repair or
alteration, misuse, abuse, neglect, accident, improper
storage and handling, fire, negligence, improper
cleaning, circumstances not directly attributable to
manufacturing defects, or act of God is not included.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED
TO, IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR USE.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state. Simply return your SWISS+TECH ® brand product
postpaid and insured to:
Swiss+Tech Products
30725 Solon Industrial Pkwy
Solon, OH 44139 USA
www.swisstechtools.com
1-800-414-8799
ST74101
Carabiner Micro Light
Battery Replacement
1. Loosen the 3 captive screws on the back
(they remain in the tool to prevent loss).
2. Remove the Glo-Ring™/button assembly.
3. Remove the old batteries.
4. Replace with two new CR1616 3V lithium
batteries or equivalent (under the bulb wire)
with positive (+) side down.
5. Replace Glo-Ring™/button assembly.
Tighten screws gently.
Two CR1616 Batteries
Positive Side (+) Down
Glo-Ring™/Button
Assembly
• Spring-loaded, carabiner-style quick clip for
effortless attachment and release.
• Solid cast aluminum body and carabiner clip.
• Soft-squeeze on/off button with Glo-Ring™.